OPERATING INSTRUCTIONS MI-410, MI-412, MI-415, MI-710

MI-410, MI-412, MI-415 and MI-710  
Micro-combination pH Microelectrodes
Operating Instructions

The microelectrode is ready to use.  Carefully unwind the tape and remove the probe from the protective glass tube.  The white translucent sleeve, which covers the hole, should be moved down the glass barrel slightly to ventilate the reference chamber and replaced after each use. 

The use of a separate Reference Electrode is not required.

Calibration

The probe can be held by hand when measuring pH.  It has been  standardized in two (2) pH buffers.  Follow the procedure recommended by the manufacturer of your pH meter for calibrating your pH meter with our microelectrode.

Optimum Response Time: Optimum response time will be obtained after the probe has been exercised in two (2) buffer solutions.  Fill one beaker with a pH 4 buffer or equivalent and a second beaker with a pH 7 buffer or equivalent.  Hold the microelectrode and touch the pH 4 buffer surface allowing 5 seconds for equilibration, and then touch the pH 7 buffer surface in the same manner.  Do this several times.  It is not necessary to rinse the probe because the carry-over is negligible.

Handling

The outer reference chamber of the microelectrode can be refilled when necessary with the 3  M  KCl  solution, using the bulb pipette.  The reference chamber should be filled slowly.

Be careful not to apply pressure against the inner glass capillary tube.

Cleaning

When using the microelectrode in solutions containing protein, it should be soaked in an enzyme cleaning solution such as  Terg-a-zyme  (Alconox, Inc.) or a chromic/sulfuric acid glass cleaning solution for a couple of minutes after each use to remove the protein from the glass and the reference junction.  This will prolong the useful life of the microelectrode.

Storage

Always clean the microelectrode before storing:

Long-term (over 2 weeks): Return the probe to its original container and prepare it in the same condition in which you received it.  Usually this means simply moistening the sponge located in the bottom of the protective glass tube with pH 4 buffer.

Short-term: The probe can be left in an acid pH buffer solution (pH 4.01).